Denon AVR-985 Operating Instructions Manual page 22

1-1 Setting the Auto Setup
1
(Remote control unit)
2
(Remote control unit)
3 Check the "Power Amp Assign" setting.
• When "Surround Back" is selected, the test tone during Auto Setup will be output from the Surround Back speaker.
• When "ZONE2" is selected, change the setting to "ZONE2" The test tone during Auto Setup is set so that it will not be output to
ZONE2 (Another room).
q Select the Power Amp Assign setting.
(Remote control unit)
4
(Remote control unit)
(Remote control unit)
22
Select "Auto Setup" at the Auto Setup / Room EQ Menu.
Display the Auto Setup screen.
q Select the "Start".
w Press the Cursor left button.
w Select "Surround Back" or "ZONE2".
(Remote control unit)
NOTE:
• When "ZONE2" is selected at System Setup Menu
"Power Amp Assign", surround back speaker is not
displayed as the target of setup in "2-1.Speaker
Config.". The results is reflected in "5-1.Power Amp
Assign".