Playback; Preparations; Turning The Power On; Operations During Playback - Denon AV SURROUND RECEIVER AVR-5308CI Owner's Manual

SOURCE SELECT <PHONES> MASTER VOLUME
<ON/STANDBY> <POWER>
[ AMP]
[POWER ON]
[MUTE]
SOURCE SELECT
About the button names in these explanations
< >
: Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit

Playback

Preparations

Turning the Power On

1
<POWER>
Press
The power indicator lights red and the power is set to the standby
mode.
2
<ON/STANDBY>
Press
The power indicator fl ashes green and the power turns on.
To operate the AVR-5308CI using the main remote control unit, set the
remote control unit to the AMP mode
Unit Operations").
Turning the Power Off
<ON/STANDBY>
q Press
The power is set to the standby mode.
<POWER>
w Press
The power indicator turns off, and so does the power.
[POWER OFF]
NOTE
Power continues to be supplied to some of the circuitry even when the
power is in the standby mode. When leaving home for long periods of
time or when traveling, either press
MASTER VOLUME
or unplug the power cord from the power outlet.

Operations During Playback

Adjusting the Master Volume
<MASTER VOLUME>
Either turn
VOLUME]
.
.
[POWER ON].
or
(vpage 76 "Remote Control
[POWER OFF]
or .
.
<POWER>
to turn off the power,
[MASTER
or press
Turning Off the Sound Temporarily (Muting)
[MUTE]
Press .
[MUTE]
To cancel, press again. Muting can also be canceled by adjusting
the master volume.
Listening with Headphones
<PHONES>
Plug the headphones into
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
Be careful not to set the volume too high when using headphones.

Playing Video and Audio Equipment

Basic Operation

1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor's operating instructions.)
2
To operate using the main remote control unit, set the
remote control unit to the AMP mode.
(vpage 76 "Remote Control Unit Operations")
3 3
Use SOURCE SELECT to select the input source.
:
"Source Select" (vpage 43, 44)
4
Start playback.
(vSee the operating instructions of the respective devices.)
.