Denon AV SURROUND RECEIVER AVR-5308CI Owner's Manual page 113

GXM Satellite RadioH
Symptom Cause
"LOADING" is • The XM Mini-Tuner is acquiring
displayed in the audio or program information
XM mode. from the XM satellite signal. This
message can also occur in weak
XM signal conditions. (Note that
the AVR-5308CI may not respond
to some buttons for XM while
this message is displayed.)
"NO SIGNAL " is • The XM Mini-Tuner
displayed in the receiving the XM satellite signal.
XM mode. Something may be blocking
the XM antenna's view of the
satellites or the antenna is not
properly aimed.
"OFF AIR" is • You selected an XM channel is
displayed in the not currently broadcasting.
XM mode.
"UP DATING" is • You selected an XM channel that
displayed in the is blocked or cannot be receive
XM mode. with your XM subscription
package.
"XM - - - " is • The selected channel is not
displayed in the available. The channel may have
XM mode. been reassigned to a different
channel number. This message
may occur initially with a new
radio or a radio that has not
received XM's signal for an
extended period.
Countermeasure
• This message should disappear
in a few seconds in good signal
conditions. If you see this
message often, reposition the
XM antenna for better signal
reception.
is not • Check for antenna obstructions
and reposition the XM antenna
to get better signal reception.
See instructions supplied with
the XM Mini-Tuner and Dock for
antenna installation information.
• Check back later; in the mean
time, select another channel.
• Consult the latest channel guide
at www.xmradio.com for the
current list of channels. For
information on receiving this
channel, visit www.xmradio.com
or contact XM Satellite Radio at
1-800-967-2346.
• Consult the latest channel guide
at www.xmradio.com for the
current list of channels. For cases
of a new radio or a radio that has
not received XM's signal for an
extended period, allow the radio
to receive the XM satellite signal
for at least 5 minutes and then
try to select the channel again.
Page
60 Specifications
n
Audio section
• Power amplifier
Rated output:
60
60, 61
Dynamic power:
–
Output connectors:
• Analog
Input sensitivity / Input impedance:
Frequency response:
S/N:
–
Distortion:
Rated output:
• Digital
D/A output:
Digital input:
• Phono equalizer (PHONO input — REC OUT)
Input sensitivity:
RIAA deviation:
S/N:
Rated output:
Distortion factor:
Front:
150 W + 150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround (A + B):
150 W + 150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround back:
150 W + 150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
200 W x 2ch (8 Ω/ohms)
340 W x 2ch (4 Ω/ohms)
Front, Center, Surround back 6 ~ 16 Ω/ohms
Surround: A or B 6 ~ 16 Ω/ohms
A + B 8 ~ 16 Ω/ohms
200 mV / 47 kΩ/kohms
10 Hz ~ 100 kHz +1, –3 dB (DIRECT mode)
102 dB (IHF–A weighted, DIRECT mode)
0.005 % (20 Hz ~ 20 kHz, DIRECT mode)
1.2 V
Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.005 % (1 kHz, at 0 dB)
Dynamic range — 110 dB
Format — Digital audio interface
2.5 mV
±1 dB (20 Hz to 20 kHz)
74 dB (A weighting, with 5 mV input)
150 mV
0.03 % (1 kHz, 3 V)
0