HEIDENHAIN MANUALPLUS 4110 Manual page 133

Create the "Form roll" cycle program
Program the "Approach tool change position" cycle

Press the Add cycle soft
key

Press the Single cuts menu
key

Press the Rapid traverse
positioning menu key

Switch to "Approach tool
change position:"
Press the T-Change
approach soft key
Enter the cycle parameters:

Sequence Q: 0
(approach the tool change position on a
diagonal path)

Tool number T: 10
(maintain T10)

Press the Input finished
soft key

Test the cycle:
Press the Graphics soft key
Run the cycle

Set the feed rate override feed rate override to 0%

Activate Cycle Start

Slowly increase the feed rate override. The tool moves to the tool change
position.

Save the cycle:
Press the Save soft key
HEIDENHAIN MANUALplus 4110 Recess Machining Example 9.9