HEIDENHAIN MANUALPLUS 4110 Manual page 31

Create tool T6 by copying
Finishing tool T6
Assume tool data and specify the position in the tool manager
The setting dimensions are assumed at first, and will be determined exactly later.

Load the tool data T2 into
the intermediate memory:
Press the Copy soft key

Place the cursor on position
T6:
Press the arrow key
repeatedly

Insert the tool data from the
intermediate memory to
position T6:
Press the Insert soft key
HEIDENHAIN MANUALplus 4110 Tool Management
Cutting radius: 0.4 mm
Tool angle: 93°
Tip angle: 55°
4.7