Parallel Interface - Ricoh Aficio MP 3500SP General Settings Manual

System Settings

Parallel Interface

This section describes the user tools in the Parallel Interface menu under Inter-
face Settings.
[Parallel Interface] is displayed when this machine is installed with the IEEE 1284
interface board.
2
❖ Parallel Timing
Specify the timing for the parallel interface. Normally, you do not need to
change this setting.
The default setting is ACK Outside.
❖ Parallel Communication Speed
Sets the communication speed for the parallel interface. If the speed is too
high, data may not be transferred smoothly. If this happens, change the set-
ting to "Standard".
The default setting is High Speed.
❖ Selection Signal Status
Sets the level for the select signal of the parallel interface.
The default setting is High.
❖ Input Prime
Sets whether to validate or invalidate the input prime signal upon reception.
Normally you do not need to change this setting.
The default setting is Invalid.
❖ Bidirectional Communication
Sets the printer's response mode to a status acquisition request when using a
parallel interface. If you experience problems using another manufacturer's
machine, set this to "Off".
The default setting is On.
When set to [Off], the bidirectional communication function will be disabled,
and the printer driver will not be installed under Windows Auto Detect func-
tion.
❖ Signal Control
Specifies how error during printing or sending facsimile from the computer
is to be dealt with. Normally, you do not need to change this setting.
The default setting is Job Acceptance Priority.
54