Table of Contents
Advertisement
Detune
A Detuner makes a copy of your incoming signal, takes the copied signal slightly out of tune from the
original, and mixes the two signals together. The result is a doubling type of effect as if two guitars
were playing the same part together.
Parameter 1 - Knob 2 selects the Amount (
Parameter 2 - Knob 3 adjusts the left/right balance of the detuned signal. Ranges from left 99 (
Knob 4 has no function when Detune is selected.
Mod Level - Knob 5 controls the level (
Pitch Shift
A Pitch Shifter copies the incoming signal, then shifts the pitch of the copied note to a different note.
The shifted note is then mixed back with the original signal sounding as if two guitars were playing
parallel notes.
Parameter 1 - Knob 2 adjusts the Amount of Pitch Shift (
Parameter 2 - Knob 3 adjusts the left/right balance of the shifted pitch. Ranges from left 99 (
Knob 4 has no function when Pitch Shift is selected.
Mod Level - Knob 5 controls the level (
Delay
Delay records a portion of the incoming signal, and plays it back a short time later. The recorded segment
can repeat just once, several times, or infinitely (that turns off the input to the Delay and lets you play
over the top of a passage in the Delay loop). The Delay in the GNX4 also includes a Ducker Threshold
that lets you set the signal strength required before the Delay records. This feature lets you control the
Delay with your playing.
Delay On/Off - The Status button turns the Delay (
Delay Type - Knob 1 selects one of the 5 different types of Delay. The Delay choices include:
(clear concise repeats)
(bounces from side to side)
(deteriorates with each repeat)
Time - Knob 2 adjusts the length of time between repeats. Ranges from 0 through 2000 milliseconds (
through 2000
appears in the Display to adjust the Delay Time in 100 ms increments.
Feedback - Knob 3 adjusts the number of times the delayed signal will repeat (
from
0
Ducker Threshold - Knob 4 adjusts the level (
*Ducker Attenuation - The Ducker Level selects the amount of attenuation applied to the Delay signal
*Delay Balance - The Delay Balance adjusts the left/right balance of the Delay signal. Ranges from L 99
Spread - This parameter increases or decreases the stereo imaging for the Spread Delay. Range is 1-50.
Delay Level - Knob 5 adjusts the volume (
*These Parameters are only available using the X-E
cents (100 cents equals 1 semitone). Ranges are from 24 cents below (-24) to 24
cents above (24).
99) to right 99 (
Ranges from 12 semitones (
99) to right 99 (
) in 1 ms increments. Use the DATA WHEEL while the Delay Time
to
99
and
signal is attenuated. Ranges from
when the Ducker Threshold has been exceeded. Ranges from 0 to 99.
to R 99.
Effects and Parameters
) of detuning applied to the copied pitch in
99).
) of the detuned note. Ranges from
) below to 24 semitones (
99).
) of the shifted pitch. Ranges from
) on and off.
(side to side with deterioration)
(clear concise repeats with stereo
imaging)
(infinite repeat).
) the input signal must reach before the Delay
1
99
to
and off (
) of the Delay signal. Ranges from
™
Editor/Librarian software.
DIT
0
) in intervals of one semi-tone.
) above.
0
). Ranges
).
0
to
to
.
to
.
0
99
.
43
Advertisement
Table of Contents
