Table of Contents
Advertisement
Other Functions
Mono/Stereo Output
The GNX2 needs to be set to stereo or mono mode. In Stereo mode, the GNX2 produces a wide
stereo image when the Right and Left Outputs are connected to two different amplifiers. In Mono mode,
the same signal appears at the Left and Right Outputs.The procedure for selecting the output mode is as
follows:
1. Press the UTILITY button. The Utility button's LED lights indicating you are in the Utility section.
2. Using the FX MODE or RHYTHM buttons, scroll to the left or right until
played as the active output mode.
3. Use the DATA WHEEL to select the output mode.
4. Press EXIT to return to the GNX2 presets.
Target System Setup
The GNX2 can be connected to any type of amplification system. However, the signal requirement
changes depending upon the type of amplification system.The Target System Setup optimizes the GNX2
for the type of amplification system it will be used with.The procedure for selecting the Target System is
as follows:
1. Press the UTILITY button. The Utility button's LED lights indicating you are in the Utility section.
2. Using the FX MODE or RHYTHM button, scroll to the left or right until one of the following target
listings is displayed
DIRECT For direct to console applications
INPT1X12 Instrument input of a 1x12 combo amp
FXLP1X12 Input into the effect return of a 1x12 combo
INPT2X12 Instrument input of a 2x12 combo amp
3. Rotate the DATA WHEEL to select the type of amplification system to be used.
4. Press EXIT to return to the GNX2 presets.
Volume Pedal Update
The GNX2 provides the option of selecting the Expression Pedal's position to be updated after changing
presets when it is linked to the Volume Parameter. This feature lets you change presets and keep the vol-
ume level from the previous preset, if the Expression Pedal controls the volume for both presets. If this
feature is disabled, new presets are set to the volume level value stored with the preset.The procedure
for enabling or disabling the Volume Pedal Update is as follows:
1. Press the UTILITY button. The Utility button's LED lights indicating you are in the Utility section.
2. Using the FX MODE or RHYTHM button, scroll to the left or right until
Update) is displayed.
3. Rotate the DATA WHEEL to select On (enabled), or OF (disabled).
4. Press EXIT to return to the GNX2 presets.
V-Switch Threshold
Applying extra pressure to the toe of the Expression Pedal engages a feature called V-Switch. V-Switch is
used to alternate between controlling assigned Parameter(s) with the pedal, and using the pedal as a Wah
pedal.The sensitivity of the V-Switch can be set to the amount of pressure you want to use. The following
steps explain how to set the V-Switch threshold:
40
FXLP2X12 Input into the effect return of a 2x12 combo
INPT4X12 Instrument input of a 4x12 combo amp
FXLP4X12 Input into the effect return of a 4x12
combo
STEREO
MONO
, or
is dis-
vOLUmPDl
(Volume Pedal
Advertisement
Table of Contents
