Direct To A Mixing Console; S/Pdif Digital Output; Applying Power - DigiTech GNX2 User Manual

Genetx guitar processor

Hide thumbs Also See for GNX2:

Table of Contents

Introduction

Direct to a Mixing Console

The GNX2 can be connected directly to the inputs of a house PA system, or a recording console.

1. Connect the guitar to the GNX2's input.

2. Connect the GNX2's outputs to the channel inputs of the mixing console.

3. If the GNX2 is to be used in Stereo mode, set the pan controls of the mixer hard left and right, and

select Stereo as the output mode from the Utility menu. See page 40 for more information on the

Output mode.

The GNX2 includes a digital S/PDIF output that connects directly to the latest digital recording devices

and sound cards. Connect the GNX2's S/PDIF output to the S/PDIF input on your digital mixer or

recorder. You must have S/PDIF inputs on the receiving device in order to use this output. Be sure to

use a 75 ohm or RCA video cable to connect from the Digital Output to a recording device. You can use

the analog and digital outputs of the GNX2 simultaneously.

NOTE: Do not connect the S/PDIF output to analog auxiliary, CD, phono, or tape inputs on con-

sumer electronic devices. It is not compatible with these inputs.

Once the audio connections are made, turn the GNX2's Output Level on the rear panel all the way down

(counterclockwise). Connect the PSS3 to the power jack on the back of the GNX2 and the other end to

an AC outlet. Turn the power switch On. Turn the power to your amplifier(s) on. Set the amp(s) to a

clean tone and set the tone controls to a flat EQ response (on most amps, this would be 0 or 5 on the

tone controls). Turn the Output Level of the GNX2 up to increase the volume.

Table of Contents