Table of Contents
Advertisement
Editing Functions
Selecting Amp/Cabinet Models
The first step to editing an Amp Model, Cabinet Type, or creating your own HyperModel™ is to select
the Amp and Cabinet types for the Green and Red Amp channels in your preset. To do this, the
GNX2 must be in the Performance mode, indicated by the Status button's LED lighting yellow. EXIT
returns you to Performance mode regardless of the selected mode. The procedure for selecting an
Amp Model or Cabinet Type for the Green or Red Amp Channels is as follows:
1. Use the Parameter 1 knob (far left) to select the Green Amp Model. The Amp Model name appears
in the alpha-numeric display. See the Amp/Cabinet Modeling section on page 13 for a complete list
of Amp Models.
2. Use the Parameter 2 knob (second from the left) to select the Green Cabinet Type. See the
Amp/Cabinet Modeling section on page 13 for a complete list of Cabinet Types.
3. Use the Parameter 4 knob (second from the right) to select the Red Amp Model.
4. Use the Parameter 5 knob (far right) to select the Red Cabinet type.
Adjusting Amp Parameters
The Gain, EQ, and Level Parameters can be adjusted individually for the Green and Red Amp
Channels.The Gain ranges from 0 (
+12
dB) to 12 (
Parameters is as follows:
1. Press the STATUS button until all horizontal LEDs across the columns light green.This indicates
that you have accessed the Amp Parameters for the Green Channel.
2. Use the Parameter 1 knob to adjust the Gain (distortion drive) for the Green Amp Channel.
3. Use the Parameter 2 knob to adjust the Bass (low frequency) enhancement for the Green Amp
Channel.
4. Use the Parameter 3 knob to adjust the Mid range frequency enhancement for the Green Amp
Channel.
5. Rotate the Parameter 4 knob to adjust the Treble (high frequency) enhancement for the Green Amp
Channel.
6. Rotate the Parameter 5 knob to adjust the Level (volume) for the Green Amp Channel.
7. Press the STATUS button again until all horizontal LEDs across the columns turn red indicating
the Amp Parameters for the Red Channel have been accessed.Then repeat steps 2 through 6 for
adjusting the Red Amp Channel.
Cabinet Tuning
The resonant frequency of the selected speaker cabinets can be tuned individually. Cabinet Tuning
ranges from
cabinets is as follows:
1. Press and hold the STATUS button. Release the Status button after about 2 seconds when the dis-
play reads Cabinet Tuning (
lit.
2. Rotate the Parameter 2 knob to adjust the tuning of the Green Cabinet type (
3. Rotate the Parameter 5 knob to adjust the tuning of the Red Cabinet type (
4. Once the tuning has been selected for both Green and Red Cabinets, press EXIT.
14
0
) to 99 (
dB).The Level ranges from 0 (
-1™0
(one octave below) to
CAB TUNe
99
).The Bass, Mid, and Treble EQ range from -12 (
0
99
) to 99 (
).The procedure for adjusting the Amp
1™0
(one octave above).The procedure for tuning the
) and only the LEDs next to the Parameter 2 and 5 knobs are
-12
GT
).
RT
).
Advertisement
Table of Contents
