H3C LS-3100-52P-OVS-H3 Operation Manual page 150

To do...
Enter system view
Enable the voice VLAN security
mode
Add a recognizable OUI
address
Enter interface view
Configure the port to operate in
manual voice VLAN
assignment mode
Access port
Assign the
port in manual
voice VLAN
Trunk port
assignment
mode to the
voice VLAN
Hybrid port
Configure the
Trunk port
voice VLAN
as the default
VLAN of the
Hybrid port
port
Enable voice VLAN on the port
An S5500-EI switch supports up to eight voice VLANs globally.
You can configure different voice VLANs on different ports at the same time. However, one port
can be configured with only one voice VLAN, and this voice VLAN must be a static VLAN that
already exists on the device.
Voice VLAN is mutually exclusive with Link Aggregation Control Protocol (LACP) on a port.
To make voice VLAN take effect on a port which is enabled with voice VLAN and operates in
manual voice VLAN assignment mode, you need to assign the port to the voice VLAN manually.
Use the command...
system-view
voice vlan security enable
voice vlan mac-address oui
mask oui-mask [ description
text ]
interface interface-type
interface-number
undo voice vlan mode auto
Refer to Assigning an Access
Port to a VLAN.
Refer to Assigning a Trunk Port
to a VLAN.
Refer to Assigning a Hybrid
Port to a VLAN.
Refer to section Assigning a
Trunk Port to a VLAN.
Refer to Assigning a Hybrid
Port to a VLAN.
voice vlan enable
3-5
Remarks
—
Optional
Enabled by default.
Optional
By default, each voice VLAN
has default OUI addresses
configured. Refer to Table 3-1
for the default OUI addresses
of different vendors.
—
Required
Disabled by default
Use one of the three
approaches.
After you assign an access port
to the voice VLAN, the voice
VLAN becomes the default
VLAN of the port automatically.
Optional
This operation is required for
untagged inbound voice traffic
and prohibited for tagged
inbound voice traffic.
Required