Ipv6 Bgp Route Reflector Configuration - H3C LS-3100-52P-OVS-H3 Operation Manual

# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] bgp 65008
[SwitchA-bgp] router-id 1.1.1.1
[SwitchA-bgp] ipv6-family
[SwitchA-bgp-af-ipv6] peer 10::1 as-number 65009
[SwitchA-bgp-af-ipv6] quit
[SwitchA-bgp] quit
# Configure Switch B.
[SwitchB] bgp 65009
[SwitchB-bgp] ipv6-family
[SwitchB-bgp-af-ipv6] peer 10::2 as-number 65008
# Display IPv6 peer information on Switch B.
[SwitchB] display bgp ipv6 peer
BGP local router ID : 2.2.2.2
Local AS number : 65009
Total number of peers : 3
Peer V
10::2 4 65008
9:3::2 4 65009
9:1::2 4 65009
# Display IPv6 peer information on Switch C.
[SwitchC] display bgp ipv6 peer
BGP local router ID : 3.3.3.3
Local AS number : 65009
Total number of peers : 2
Peer V
9:3::1 4 65009
9:2::2 4 65009
Switch A and B has established an eBGP connection; Switch B, C and D have established iBGP
connections with each other.

IPv6 BGP Route Reflector Configuration

Network requirements
As shown in the following figure, Switch B receives an eBGP update and sends it to Switch C, which is
configured as a route reflector with two clients: Switch B and Switch D.
Switch B and Switch D need not establish an iBGP connection because Switch C reflects updates
between them.
AS MsgRcvd MsgSent
3 3
2 3
2 4
AS MsgRcvd MsgSent
4 4
4 5
Peers in established state : 3
OutQ PrefRcv Up/Down
0 0 00:01:16 Established
0 0 00:00:40 Established
0 0 00:00:19 Established
Peers in established state : 2
OutQ PrefRcv Up/Down
0 0 00:02:18 Established
0 0 00:01:52 Established
1-22
State
State