H3C LS-3100-52P-OVS-H3 Operation Manual page 12

Features
BPDU Tunneling
VLAN Mapping
Ethernet OAM
Connectivity Fault
Detection
MSTP
RRPP
BPDU tunneling enables transparently transmission of customer network
BPDU frames over the service provider network. This document
describes:
Introduction to BPDU Tunneling
Configuring BPDU Transparent Transmission
Configuring Destination Multicast MAC Address for BPDU Tunnel
Frames
The VLAN mapping feature maps CVLAN tags to SVLAN tags. This
document describes:
Configuring One-to-One VLAN Mapping
Configuring Many-to-One VLAN Mapping
Configuring Two-to-Two VLAN Mapping
Ethernet OAM is a tool monitoring Layer-2 link status. It helps network
administrators manage their networks effectively. This document
describes:
Ethernet OAM overview
Configuring Basic Ethernet OAM Functions
Configuring Link Monitoring
Enabling OAM Loopback Testing
Connectivity fault detection is an end-to-end, per-VLAN link-layer OAM
mechanism for link connectivity detection, fault verification, and fault
location. This document describes:
Connectivity Fault Detection Overview
Basic Configuration Tasks
Configuring CC on MEPs
Configuring LB on MEPs
Configuring LT on MEPs
MSTP is used to eliminate loops in a LAN. It is compatible with STP and
RSTP. This document describes:
Introduction to MSTP
Configuring the Root Bridge
Configuring Leaf Nodes
Performing mCheck
Configuring Digest Snooping
Configuring No Agreement Check
Configuring Protection Functions
RRPP is a link layer protocol designed for Ethernet rings. RRPP can
prevent broadcast storms caused by data loops when an Ethernet ring is
healthy, and rapidly restore the communication paths between the nodes
after a link is disconnected on the ring. This document describes:
RRPP overview
Configuring Master Node
Configuring Transit Node
Configuring Edge Node
Configuring Assistant Edge Node
Configuring Ring Group
3-3
Description