Configuring Rip-To-Mib Binding; Configuring The Rip Packet Sending Rate - H3C LS-3100-52P-OVS-H3 Operation Manual

To do...
Specify a RIP neighbor
Disable source address check
on incoming RIP updates
You need not use the peer ip-address command when the neighbor is directly connected;
otherwise the neighbor may receive both the unicast and multicast (or broadcast) of the same
routing information.
If a specified neighbor is not directly connected, you need to disable source address check on
incoming updates.

Configuring RIP-to-MIB Binding

This task allows you to enable a specific RIP process to receive SNMP requests.
Follow these steps to bind RIP to MIB:
To do...
Enter system view
Bind RIP to MIB

Configuring the RIP Packet Sending Rate

RIP periodically sends routing information in RIP packets to RIP neighbors.
Sending large numbers of RIP packets at the same time may affect device performance and consume
large network bandwidth. To solve this problem, you can specify the maximum number of RIP packets
that can be sent at the specified interval.
Follow these steps to configure the RIP packet sending rate:
To do...
Enter system view
Enable a RIP process and
enter RIP view
Configure the maximum
number of RIP packets that
can be sent at the specified
interval
Use the command...
peer ip-address
undo validate-source-address
Use the command...
system-view
rip mib-binding process-id
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
output-delay time count count
1-15
Required
Required
Not disabled by default
Remarks
––
Optional
By default, MIB is bound to RIP process 1.
––
––
Optional
By default, an interface sends
up to three RIP packets every
20 milliseconds.
Remarks
Remarks