Configuring Ripv2 Message Authentication; Specifying A Rip Neighbor - H3C LS-3100-52P-OVS-H3 Operation Manual

To do...
Enter system view
Enter RIP view
Enable source IP address
check on incoming RIP
messages
The source IP address check feature should be disabled if the RIP neighbor is not directly connected.

Configuring RIPv2 Message Authentication

RIPv2 supports two authentication modes: plain text and MD5.
In plain text authentication, the authentication information is sent with the RIP message, which however
cannot meet high security needs.
Follow these steps to configure RIPv2 message authentication:
To do...
Enter system view
Enter interface view
Configure RIPv2
authentication
This task does not apply to RIPv1 because RIPv1 does not support authentication. Although you can
specify authentication modes for RIPv1 in interface view, the configuration does not take effect.

Specifying a RIP Neighbor

Usually, RIP sends messages to broadcast or multicast addresses. On non broadcast or multicast links,
you need to manually specify RIP neighbors. If a specified neighbor is not directly connected, you must
disable source address check on incoming updates.
Follow these steps to specify a RIP neighbor:
To do...
Enter system view
Enter RIP view
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
validate-source-address
Use the command...
system-view
interface interface-type interface-number
rip authentication-mode { md5 { rfc2082
key-string key-id | rfc2453 key-string } | simple
password }
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
1-14
Remarks
––
––
Optional
Enabled by default
Remarks
––
––
Required
Remarks
––
––