Configuring Ospf Route Redistribution - H3C LS-3100-52P-OVS-H3 Operation Manual

Network 10.2.1.1
Sum-Net 10.5.1.0
Sum-Net 10.3.1.0
Sum-Net 10.1.1.0
Sum-Asbr 10.3.1.1
# Display OSPF routing information on Switch D.
[SwitchD] display ospf routing
OSPF Process 1 with Router ID 10.5.1.1
Routing for Network
Destination
10.2.1.0/24
10.3.1.0/24
10.4.1.0/24
10.5.1.0/24
10.1.1.0/24
Total Nets: 5
Intra Area: 2
# On Switch D, ping the IP address 10.4.1.1 to check connectivity.
[SwitchD] ping 10.4.1.1
PING 10.4.1.1: 56
Request time out
Reply from 10.4.1.1: bytes=56 Sequence=2 ttl=253 time=2 ms
Reply from 10.4.1.1: bytes=56 Sequence=3 ttl=253 time=1 ms
Reply from 10.4.1.1: bytes=56 Sequence=4 ttl=253 time=1 ms
Reply from 10.4.1.1: bytes=56 Sequence=5 ttl=253 time=1 ms
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/2 ms

Configuring OSPF Route Redistribution

Network requirements
As shown in the following figure:
All the switches run OSPF, and the AS is divided into three areas.
Switch A and Switch B act as ABRs to forward routes between areas.
Switch C is configured as an ASBR to redistribute external routes (static routes). Routing
information is propagated properly in the AS.
10.2.1.1
10.2.1.1
10.2.1.1
10.2.1.1
10.2.1.1
Routing Tables
Cost Type
22 Inter
10 Transit 10.3.1.2
25 Inter
10 Stub
12 Inter
Inter Area: 3 ASE: 0
data bytes, press CTRL_C to break
769 32 80000010
769 28 80000003
1069 28 8000000F
1069 28 8000000F
1069 28 8000000F
NextHop AdvRouter
10.3.1.1 10.3.1.1
10.3.1.1
10.3.1.1 10.3.1.1
10.5.1.1 10.5.1.1
10.3.1.1 10.3.1.1
NSSA: 0
1-49
0
14
4
2
2
Area
0.0.0.2
0.0.0.2
0.0.0.2
0.0.0.2
0.0.0.2