Configuring Join/Prune Message Sizes - H3C LS-3100-52P-OVS-H3 Operation Manual

To do...
Configure the join/prune
interval
Configure the join/prune
timeout time
Configure assert timeout time
Configure the multicast source
lifetime
Configuring PIM common timers on an interface
Follow these steps to configure PIM common timers on an interface:
To do...
Enter system view
Enter interface view
Configure the hello interval
Configure the maximum delay
between hello messages
Configure the join/prune
interval
Configure the join/prune
timeout time
Configure assert timeout time
If there are no special networking requirements, we recommend that you use the default settings.

Configuring Join/Prune Message Sizes

A larger join/prune message size will result in loss of a larger amount of information when a message is
lost; with a reduced join/message size, the loss of a single message will bring relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively
reduce the number of (S, G) entries sent per unit of time.
Follow these steps to configure join/prune message sizes:
Use the command...
timer join-prune interval
holdtime join-prune interval
holdtime assert interval
source-lifetime interval
Use the command...
system-view
interface interface-type
interface-number
pim timer hello interval
pim triggered-hello-delay
interval
pim timer join-prune interval
pim holdtime join-prune
interval
pim holdtime assert interval
1-34
Remarks
Optional
60 seconds by default
Optional
210 seconds by default
Optional
180 seconds by default
Optional
210 seconds by default
Remarks
—
—
Optional
30 seconds by default
Optional
5 seconds by default
Optional
60 seconds by default
Optional
210 seconds by default
Optional
180 seconds by default