Installing The Mounting Brackets And Cable Management Bracket; Replacing A Memory Module; Upgrade Description - 3Com LS8M1P12TEH Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches
6.6 Installing the Mounting Brackets and Cable Management
Bracket
Two mounting brackets and a cable management bracket are shipped with the S7500
series.
Take the following steps to install the mounting brackets and the cable management
bracket:
1) Face the LPU slots of the switch.
2) Attach the shipped left and right mounting brackets onto the left and right sides of
the chassis, respectively.
3) Install the shipped cable management bracket onto the left side (opposite to the
fan tray) of the chassis, as shown in Figure 6-6.
Mounting bracket Mounting bracket
Figure 6-6 Install the supplied cable management bracket for the S7506

6.7 Replacing a Memory Module

Note:
This section introduces how to replace a memory module on any type of board.

6.7.1 Upgrade Description

The memory module can be upgraded or replaced according to your requirement.
Generally, you need to upgrade the memory module in one of the following cases:
More memory space is needed when you upgrade the application programs of the
switch.
挂耳 挂耳
Cable managem ent bracket Cable managem ent bracket
走线架 走线架
6-9
Chapter 6 Hardware Maintenance
挂耳 挂耳
Mounting bracket Mounting bracket