3Com LS8M1P12TEH Installation Manual page 146

Installation Manual
H3C S7500 Series Ethernet Switches
Caution:
The FTP Server program is not supplied with the S7500 series.
When loading a Boot ROM or host software, you need to use a crossover cable to
connect the management Ethernet port.
3) Run the terminal emulation program on the PC connected to the console port.
Start the switch, and enter the Boot menu and then the BootROM update menu.
To download a Boot ROM program, press Ctrl+U and Enter to enter the Boot ROM
update menu when the terminal displays "Enter your choice (0-5):".
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):2
4) In the BootROM update menu, select 2 to download the Boot ROM or host
software. Press Enter and configure the FTP parameters:
Load File name:
Switch IP address:
Server IP address:
FTP User Name:
FTP User Password:
5) Enter the FTP parameter values and then press Enter. The terminal displays the
following information:
Are you sure to update SRPG bootrom? Yes or No(Y/N)
6) Type Y to start file downloading or N to return to the BootROM update menu. If you
type Y and press Enter, the system starts program downloading. After the
program is downloaded, the system writes the program to the Flash memory. The
terminal displays the following information after the write operation:
......
SRPG bootrom is updating now......
Get flash Type......FLASH_M29W040B
Erasing flash......done!
Programming flash......done!
Checking flash......done!
III. Loading host software
Follow these steps to load the host software of the switch:
1) Select 1 from the Boot menu. The terminal displays the following information:
1. Set TFTP protocol parameter
Chapter 7 Software Maintenance
7-11