Mounting The Switch In A Rack; Preparations; Installing The Cable Management Bracket And Rack-Mounting Ears - 3Com LSBM1SRP1M1 Installation Manual

Installation Manual
H3C S9500 Series Routing Switches

3.3 Mounting the Switch in a Rack

3.3.1 Preparations

Before installation, make sure that:
The cabinet is grounded and stable. The layout inside the cabinet for switch
installation has been well done and there is no obstacle inside or around the
cabinet.
The switch is ready for installation and has been carried to a place near the
cabinet.

3.3.2 Installing the Cable Management Bracket and Rack-Mounting Ears

For your convenience, a cable management bracket is shipped with the S9500 series.
Take the following steps to install the cable management bracket.
1) Facing the LPU slots of the switch, insert the shipped cable management bracket
into the left rack-mounting ear on which there is a recessed hole for installing the
cable management bracket, and fix it with screws. (One cable management
bracket for the S9502/S9505/S9508/S9508V and two for the S9512).
2) Install the rack-mounting ears onto the both sides of the switch, as shown in Figure
3-2.
Figure 3-2 Install the cable management bracket and rack-mounting ears
3-2
Chapter 3 Switch Installation