3Com LS8M1P12TEH Installation Manual page 253

Installation Manual
H3C S7500 Series Ethernet Switches
(1) Lower enclosure frame
(4) Spring washer 6
Figure B-52 Install cabinet feet
Remove the plastic shims and steel shims in the holes on the lower enclosure frame,
and then fasten the feet on the lower enclosure frame. Adjust the adjustment nuts on
the feet to the required height so that four feet get the same height.
Note:
The four feet come in two types, which are identified by R and L respectively. Be
sure to choose the correct type in the installation.
The plastic shims and steel shims remain in the cabinet after installation of the feet.
However, they will not affect the normal work of the cabinets.
3) Install cover plates.
After installing the feet, put the cabinet in the upright position. Press the cover plates in
the holes on the lower enclosure frame, and then fix the cabinet, as shown in
Figure B-53.
(2) Cabinet foot
(5) Bolt M6x16
B-55
Appendix B N68 Cabinet Installation
(3) Flat washer 6