Table of Contents
Advertisement
Appearance of a rear mounting bracket
Figure 3-3 Rear mounting bracket of the WX3024
(1)
(1) Screw holes for fixing the rear mounting bracket
onto the rack (using M6 screws)
Introduction to Slide Rails
The slide rails are optional components that need to be separately ordered if needed for the installation
scenario selected in Table 3-1.
Appearance of a slide rail
Figure 3-4 A slide rail
(1) Slot hole for fixing the slide rail onto the rear bracket of the rack. It allows adjustment of the device
mounting screw position according to the device position.
(2) Heat dissipation holes. Holes for heat dissipation between the device and the rack.
(3) Slot hole for fixing the slide rail onto the front bracket of the rack.
Installing the Device Using Front Mounting Brackets
Follow these steps to install the device (take the WX3010 for example) using front mounting brackets:
Step1 Put on an ESD-preventive wrist strap and verify that the rack is sturdy and properly grounded.
(2)
(2) Heat dissipation holes
3-3
Advertisement
Table of Contents
