Table of Contents
Advertisement
70
C
4: S
HAPTER
WITCH
Cable Routing
Recommendations
Freestanding Switch on
Tabletop
Cabinet-Mounting
Switch
Cable Management
Cable Management
Requirements
I
NSTALLATION
Figure 51 LC connector
Connecting fiber
Step 1: Plug one end of the fiber into the SFP optical module of the Switch 8800
Family.
Step 2: Connect the other end of the fiber into the corresponding device.
c
CAUTION: When the optical interface has not been connected with a fiber
connector or its dust-proof mesh is open, there might be some invisible radiation
emitted from the optical interface. So do not look into the optical interface
directly.
Cover the optical interface if there is no connector plugged in.
For only selling an integrated chassis, you do not have to care about the cabling
inside or outside the cabinet. All the I/O module cables are routed from the left
side of the chassis (along the cabling channel), and the chassis power cords
(AC/DC power cords) are routed in the front of the chassis.
If the switch is mounted in a 19-inch standard cabinet or B68-22 cabinet, the I/O
module cables are bound on the cabling rack at the left side of the chassis and are
routed up or down to pass through the chassis top or the raised floor depending
on the available equipment room condition (that is, the signal cables are routed
into the chassis either from the cabling rack on the chassis top or from the cabling
trough under the floor) of the exchange office. The power cords run along the
left-front of the chassis and out of the chassis either from the top or the raised
floor depending on the equipment room conditions (DC power distribution
cabinet, lightning protection box, and terminal block, etc.) of the exchange office.
Bundle and put the cables inside the cabinet in a straight and neat way. No
■
intertwinement or bending is allowed.
Advertisement
Table of Contents
