Installing And Removing The Dedicated Cx4 Cable - 3Com 4800G Getting Started Manual

50 C 3: I
HAPTER NSTALLING THE
Short-haul Dual-port 10
GE CX4 Interface Module
Installing and
Removing the
Dedicated CX4 Cable
Installing the Dedicated
CX4 Cable
S
WITCH
Appearance and front panel of a short-haul dual-port 10 GE CX4 interface
module
Figure 52 Appearance of a short-haul dual-port 10 GE CX4 interface module
Figure 53 Front panel of a short-haul dual-port 10 GE CX4 interface module
Installation and removal
The installation and removal procedures of CX4 interface modules are the same as
those of XFP interface modules. Refer to "Installation procedure" on page 48
"Installation procedure" on page 48 and "Removal procedure" on page 49
"Removal procedure" on page 49 for it.
n
Make sure that you have installed a CX4 interface module before installing the
dedicated CX4 cable.
1 Wear an ESD-preventive wrist strap and verify the ESD-preventive wrist strap
properly grounded. Then take out the dedicated CX4 cable from the package.
2 Horizontally insert the dedicated CX4 cable connector into the CX4 port of the
switch.