Table of Contents
Advertisement
Installation Manual
H3C S3610 Series Ethernet Switches
Step 1: Use a flat-blade screwdriver to loosen screw 1 and screw 2 on the DC input
terminal block. Connect DC power terminals of the switch to –48 VDC power supply
through DC power cables, with NEG (-) connected to the –48V output of the –48 VDC
power supply and RTN (+) to the working ground. Tighten screw 1 and screw 2
respectively to fix the power cables.
Step 1: Check whether the PWR LED on the front panel of the switch is ON. If yes, the
power is properly connected.
Caution:
Before powering on the switch, you should properly connect the grounding wire.
The DC power cable should be less than 3 meters (9.8 ft.) long.
II. 12V-RPS DC power cable connection for S3610-52M/S3610-52M-DC
Ethernet switch
Pin Number
1
2
3
4
5
6
7
Figure 3-10 12V-RPS DC power socket
1)
Connect one end of the grounding cable (delivered with the switch) to the
grounding screw and the other end to the ground nearby.
2)
Connect the 12V-RPS DC power supply as follows:
As shown in Figure 3-11, loosen the fastening screws and remove the air filter
from the 12V-RPS DC power socket. (In the case of no 12V-RPS DC power supply,
re-install the air filter.)
Designation
Pin Number
GND
8
—
9
12V
10
12V
11
12V
12
12V
GND
14
3-7
Chapter 3 Installing the Switch
Designation
GND
—
RPS_pres
—
—
13
Control Pin
GND
Advertisement
Table of Contents
