3Com LS-S3610-52P-OVS Installation Manual page 20

Installation Manual
H3C S3610 Series Ethernet Switches
LED
1000Base
SFP port
status LED
III. Fixed 10Base-T/100Base-TX Ethernet ports
For the attributes of the 10Base-T/100Base-TX Ethernet ports, see Table 1-3.
IV. 1000 Mbps SFP ports
The S3610-28P provides up to four 1000 Mbps SFP ports on its front panel. You can
determine the number and the types of the ports according to your needs.
The SFP modules that can be connected with the ports are hot-swappable and
multifarious. This brings flexibility to your actual networking.
You can choose the SFP modules listed in Table 1-4 as required.
Note:
For specifications of each SFP module, refer to H3C Low-End Series Ethernet
Switches Pluggable Module Manual.
The available SFP modules may change as time goes by. Contact the H3C
marketing or technical support personnel for the latest available SFP modules.
V. Console port
The S3610-28P provides an EIA/TIA-232-compliant console port. You can use this port
to configure the switch locally or remotely. See Table 1-6 for the attributes of the
console port.
Mark Status
Green
Speed
Flashing yellow
(at 3 Hz)
OFF
—
Green
Duplex
Flashing yellow
(at 3 Hz)
OFF
1-12
Chapter 1 Product Overview
Meaning
The port works at 1000
Mbps; when it
receives/sends data, the
LED flashes quickly.
The port fails the POST.
The port is disconnected.
The port works at 1000 Mbps
in full duplex mode; when it
receives/sends data, the
LED flashes quickly.
The port fails the POST.
The port is disconnected.