3Com LS-S3610-52P-OVS Installation Manual page 30

Installation Manual
H3C S3610 Series Ethernet Switches
Note:
S3610-52M and S3610-52M-DC switches have the same front panels. The following
takes the front panel of S3610-52M switch as an example.
On its front panel, the S3610-52M/S3610-52M-DC switch provides six slots where you
can insert
10Base-T/100Base-TX modules, and 8-port 100 Mbps SFP modules as needed. The
following figure illustrates the front panel with all the six slots inserted with 8-port 100
Mbps single-mode modules:
(1) Power LED
Figure 1-9 Front panel of the S3610-52M
Caution:
The interface modules on the front panel of the H3C S3610-52M and S3610-52M-DC
are not hot-swappable. To install or remove these modules, you must first power off the
switch. For how to install and remove these modules, refer to section 3.4 "Installation
of the Optional Interface Modules".
II. LED
The S3610-52M/S3610-52M-DC switch provides one power LED only on the front
panel. After you insert an interface module in a slot, you can know the port working
status based on the LEDs on the interface module. For description on the LEDs of the
interface modules, refer to Chapter 7 "Optional Interface Modules" in page 7-1.
III. Interface modules
8-port 100Base-FX multimode module
8-port 100Base-FX single-mode module
the 8-port 100 Mbps
1-22
Chapter 1 Product Overview
single-mode/multimode modules, 8-port
(1)