Table of Contents
Advertisement
Installation Manual
H3C S3610 Series Ethernet Switches
Place the switch on the tray horizontally, slide the tray into the cabinet, and fix the other
end of mounting ears to the front brackets with crews and captive nuts, as shown in
Figure 3-4.
V. Use front mounting ears and guide rails
Follow these steps to install a switch into a 19-inch standard cabinet:
1)
Wear an ESD-preventive wrist strap to check the grounding and stability of the
cabinet.
2)
Take out the screws packed together with the front mounting ears and fix one end
of the front mounting ears to the switch, as shown in Figure 3-3.
3)
Install guide rails on the brackets on both sides of the cabinet with M5 self-tapping
screws, as shown in Figure 3-5.
Figure 3-5 Install guide rails
4)
Hold the two sides of the switch and slide it gently along the guide rails into the
cabinet until it is located in a proper position, as shown in Figure 3-6. Ensure that
the bottom side of the guide rails and the switch are in close contact.
Figure 3-6 Install front mounting ears and guide rails
3-4
Chapter 3 Installing the Switch
Front panel
Advertisement
Table of Contents
