Camber Flap - FUTABA 10CAP Instruction Manual

Flap Setting ( CAMBER FLAP )( GLID ):
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Center position ( CENTER
[Note] When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
GOAL of EXAMPLE:
Ex: Set the maximum travel of 35 % of Open the CAMBER FLAP function.
CAMBER FLAP assigns the primary flap control [defaults to VR(A)] to allow
NOTE: If FLAP-TRIM is activated, you can not use CAMBER FLAP function
simultaneously.
STEPS:
separately.
(Ex: adjust to 35% .)
Option: Adjust the center position of
Close menu.
86
FLP1 2 ) can be adjusted
INPUTS:
for 1 second.
(If BASIC ,
to CAMBER FLAP .
C
C to FLP1 . VR(A).
VR(A). to 35% . Repeat.
C to CENTER . to desired point.
again.)
to 35% .