Elev-Flap - FUTABA 10CAP Instruction Manual

ELEV-FLAP mixing ( ACRO GLID ):
( ACRO )
( GLID )
GOAL of EXAMPLE:
Activate ELEV-FLAP mixing. Adjust flap
travel to 0%
(push) and 45% flaps with positive
elevator.
Where next?

ELEV-FLAP

commonly used to make tighter pylon turns or squarer corners in maneuvers. In
Adjustability:
• Rate
to provide full up elevator.)
• Switch: fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up
LOGIC SW : See p. 38.
*IF you set it to NULL , the mix does not work. ( ACRO )
•Range ( GLID ): The range that mixing does not work near neutral of an elevator
stick can be set up.
Hold the stick to the desired point (upper or lower side) , then press DIAL and
hold one second to set the range.
• Condition ( GLID ): The separate ELEV-FLAP settings for each condition can be set.
STEPS:
Open the ELEV-FLAP function.
Activate the function.
Adjust the travels as needed.
(Ex: 0% ,to 45% .)
Close menu.
Set up AIRBRAKE
Set up programmable mixes (ex: FLAP-ELEVATOR ): see p. 68.
View additional setups on the internet: www.futaba-rc.com\faq\.
62
ELEVATOR STICK is moved. It is most
when the ELEVATOR STICK is pulled
INPUTS:
for 1 second.
(If BASIC ,
C to ELEV-FLAP .
to MIX . to ACT .
C
C to RATE .
ELEVATOR STICK.
ELEVATOR STICK.
FLAPERON ): see p. 52.
again.)
to 0% .
to 45% .