Aile/Rudd - FUTABA 10CAP Instruction Manual

AILE RUDD ( GLID ):
Adjustability:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW : See p. 38.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
positions of the same SWITCH.
• Condition: The separate AILE RUDD
GOAL of EXAMPLE:
corrects roll coupling.
Where next?
You can select a pre-programed mix which is used to mix the rudders with
aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix ( AILE RUDD ): automatically creates a "coordinated turn".
Rudder -to-aileron mix ( RUDD AILE ): used to counterract undesirable roll (roll
coupling) that happens with rudder input, especially in knife-edge.
STEPS:
Open AILE RUDD mix submenu.
Select the mixing mode.
Activate the function.
Set the rate. (Ex: 100% each way)
Repeat as needed.
Close.
ELEV-FLAP mixing. See p. 62.
BUTTERFLY . See p. 63.
Use a mix to OFFSET
View additional model setups on the internet: www.futaba-rc.com\faq\
81
INPUTS:
for 1 second.
(If BASIC ,
to 2nd page of menu.
C to AILE RUDD .
C to MODE . to RUDD AILE
C to MIX to ON .
to FLP1 .
C
RUDDER STICK.
RUDDER STICK.
again.)
to +25% .
to +25% .