Glider-Specific Basic Menu Functions; Model Type ( Parameter Submenu) - FUTABA 10CAP Instruction Manual

Those functions which are identical to the ACRO setups are referred directly to those pages.
MODEL TYPE : This function of the PARAMETER submenu is used to select the type of model programming to be used.
GLIDER TYPES:
GLID(1A+1F)
(FLAPERON)
AIL2
FLP1
(CH6)
• ACRO
• ACRO provides:
• SNAP-ROLL ,
• AILEVATOR (twin elevator servo support),
• AIRBRAKE (a more assignable version of BUTTERFLY ).
• For nitro-powered sailplanes: IDLE-DOWN , THR-CUT , THROTTLE-NEEDLE mixing and THROTTLE DELAY programming.
• But ACRO
Start, Speed, Distance and Landing.
• GLID(1A+1F) : The GLID(1A+1F) MODEL TYPE is intended for sailplanes with one or two aileron servos (or none), and a single
• GLID(2A+1F) : The GLID(2A+1F) MODEL TYPE
trims and aileron differentials to make the sailplane perform certain maneuvers more easily.
• GLID(2A+2F) : The GLID(2A+2F) MODEL TYPE supports dual flap servos that can also act as ailerons, creating full-span
differentials to make the sailplane perform certain maneuvers more easily.
GOAL of EXAMPLE:
Change model1 is MODEL T YPE to
GLID(1A+1F) .
NOTE: This is one of the several
functions that the radio requires
GLID -SPECIFIC FUNCTIONS STEP BY STEP.
AIL2
(CH7)
AIL1
FLP2
(CH1)
ACRO is a better choice because of functions it offers that the GLID types do not.
STEPS:
Confirm you are currently using the
proper model memory. (Ex: 1)
Open PARAMETER submenu.
Change the MODEL TYPE .
Close.
GLID(2A+1F)
AIL1
(CH1)
FLP
(CH6)
TYPE is meant to be a very simplistic version to set up a basic
78
GLID(2A+2F)
AIL2 AIL1
FLP1 FLP2
(CH7) (CH1)
(CH6) (CH5)
MODEL TYPE
INPUTS:
On home screen, check model nameand
number on top left.
If it is not the correct model (Ex: 1), use
MODEL SELECT , p. 25.
for 1 second.
(If ADVANCE ,
to 2nd page of menu.
C to PARAMETER .
C to TYPE . to GLID(1A+1F) .
for one second.
Are you sure?
again.)