Glossary - FUTABA 10CAP Instruction Manual

GLOSSARY

rolls. Helicopters: combining 2 or more maneuvers, such as rolling loop.
4.8V: 4.8 volt battery pack, made of 4 Ni-Cd 1.2V cells. See Accessories.
5-cell: 6.0 volt battery pack, made of 4 alkaline cells or 5 Ni-Cd cells. See Accessories.
6V (6Volt): battery pack, made of 4 alkaline cells or 5 Ni-Cd cells. See Accessories.
ACCELERATION : a delay mix which richens engine mixture and then returns to normal to compensate for abrupt throttle
changes. See THROTTLE-NEEDLE. ............................................................................................................................................ 65
Accessories: additional optional items which may be used with your 10C. ........................................................................ 10
ACRO : model type designed for use with powered aircraft. Selected in the MODEL submenu under TYPE . ........................... 34
ACRO vs GLID comparison. .................................................................................................................................................... 34
ACT . Active. Make a feature able to be utilized. Opposite of INH . Only visible in certain features.
Adjustable Function Rate: see SWASH AFR .
END POINT .
Adjustable Travel Limited ( ATL ): End point adjustment for low end only, for throttle channel. See ATL .
END POINT .
ADVANCE
advanced features.
AFR: Adjustable function rate. Used only in HELI model types with CCPM heads. See SWASH AFR .
AILE-2 : second aileron servo assignment. See Twin aileron servos.
AILE1/2/3/4 : Designation for the individual servos that are being commanded by the aileron command. Ex: when using
ailevators, the two elevator servos are also acting as ailerons 3 and 4 (unless you set their values to 0 ). See Twin aileron
servos and Twin elevator servos.
AILE/RUDD ( GLID ): You can select a pre-programed mix which is used to mix the rudders with aileron operation or the
especially in knife-edge. ...................................................................................................................................................... 81
Aileron: surface that controls the roll of the model. Also called cyclic roll on a helicopter.
Programmable
mix. This is the default setup of one mix in GLID .
Aileron-to-rudder mix: Mixing that automatically creates a "coordinated turn". Not a preprogrammed mix. See
Programmable mix. This is the default setup of one curve mix in HELI GLID .
Aileron Differential: Decreased down aileron travel when compared to up aileron travel. Minimizes "dragging" the low
wing and creates more axial rolls. See Twin aileron servos. .............................................................................................. 51
Ailevator: two elevators on separate channels, also capable of acting as additional ailerons. See Twin elevator servos.
AILEVATORS : ( ACRO ) Twin elevator servos plugged into separate channels, used to control elevator with the option to also
act as ailerons in conjunction with the primary ailerons. ..................................................................................................... 56
Airbrake-to-elevator mixing: ( GLID ) Applies up or down elevator when airbrakes are deployed, correcting for any pitch
change from the added drag. Not a preprogrammed mix. See Programmable mix.
Airbrake: ( GLID CHANNEL 3 (NORMALLY THROTTLE) STICK.
AIRBRAKE : ( ACRO
110