Enable The Edge To Use Mobile Vpn With Ssl - Watchguard Firebox X15 User Manual

About Mobile VPN with SSL
7. In the Session idle timeout field, set the length of time the computers in this group can stay
authenticated when idle (not passing any traffic to the external network, through the Branch Office
VPN, or to the Firebox X Edge itself). A setting of zero (0) minutes means there is no idle timeout.
8. If you want the users in this group to have Internet access, select the Allow access to the External
Network check box.
9. If you want the users in this group to have access to computers on the other side of a Branch Office VPN
tunnel, select the Allow access to manual and managed VPN tunnels check box.
10. If you want the users in this group to be able to use Mobile VPN with PPTP to the Edge for secure
remote access, select the Allow remote access with Mobile VPN with PPTP check box.
11. If you want the users in this group to be able to use Mobile VPN with SSL to the Edge for secure remote
access, select the Allow remote access with Mobile VPN with SSL check box.
12. Click Submit.

Enable the Edge to use Mobile VPN with SSL

1. To connect to the System Status page, type
of the Firebox X Edge trusted interface.
The default URL is https://192.168.111.1
2. From the navigation bar, select VPN > Mobile VPN with SSL.
The SSL VPN page appears.
3. To enable Mobile VPN with SSL, select the Enable Mobile VPN with SSL check box.
4. Configure the settings on the General and Advanced tabs. Each setting is described below.
292
in the browser address bar, and the IP address
https://
Firebox X Edge e-Series