Connect And Disconnect The Mobile Vpn Client - Watchguard Firebox X15 User Manual

Uninstall the Mobile VPN client
At some point, it can become necessary to uninstall the Mobile VPN client. We recommend that you use the
Windows Add/Remove Programs tool to uninstall the Mobile VPN client. After the Mobile VPN client software
is installed the first time, it is not necessary to uninstall the Mobile VPN client software before you apply any
upgrades to the client software.
Before you start, disconnect all tunnels and close the Mobile VPN Connection Monitor. Then, from the
Windows desktop:
1. Click Start > Settings > Control Panel.
The Control Panel window appears.
2. Double-click the Add/Remove Programs icon.
The Add/Remove Programs window appears.
3. Select WatchGuard Mobile VPN and click Change/Remove.
The InstallShield Wizard window appears.
4. Click Remove and click Next.
The Confirm File Deletion dialog box appears.
5. Click OK to completely remove all of the components. If you do not select this box at the end of the
uninstall, the next time you install the Mobile VPN software the connection settings from this
installation populate in the next installation.

Connect and disconnect the Mobile VPN client

The WatchGuard Mobile VPN with IPSec client software makes a secure connection from a remote computer
to your protected network over the Internet. To start this connection, you must connect to the Internet and
use the Mobile VPN client to connect to the protected network.
Start your connection to the Internet through a Dial-Up Networking connection or LAN connection. Then, use
the instructions below or select your profile, connect, and disconnect by right-clicking the Mobile VPN icon on
your Windows toolbar.
1. From your Windows desktop, select
Start > All Programs > WatchGuard Mobile VPN > Mobile VPN Monitor.
2. From the Profile drop-down list, select the name of the profile you created for your Mobile VPN
connections to the Firebox. Click Connect.
User Guide
About Mobile VPN with IPSec
279