Audio Accessory Note; Keyboard And Mouse; Connecting The Power Cord - HP Server rx2600 Installation Manual

Setting Up and Using Your System
Connecting Devices
NOTE
22

Audio Accessory Note

The small steel clip attached to your headset connector (see below)
reduces radio frequency interference and allows your system to meet
international regulatory requirements.
If you connect any other audio accessories to the system, attach one of
these clips to each additional connector as shown.
Surround sound is not supported on the zx6000 or rx2600 systems.

Keyboard and Mouse

The HP A7861A keyboard and mouse provide the basic input accessories
necessary to get you started with your workstation. The PC-104/105,
-106 key or JIS-109 keyboard is available in 13 different localized
layouts, and fully conforms to industry standards.
The A7861A kit provides a choice of 3-button scroll-wheel mouse
(standard) or 3-button plain mouse (specify product Option 065). Both
the keyboard and the mouse have an extended-length 2.9m (9.5 foot)
cable, which allows more flexible positioning of the system than is
possible with the 1.8m cable on typical PCs. The keyboard and mouse are
connected to the USB connectors on the rear panel of the computer.

Connecting the Power Cord

You will notice that there are two power cord receptacles on the rear
panel of the system. These are redundant receptacles to be used in those
cases where a redundant power supply is required. One of the
receptacles (PWR2) may be covered by a plastic cap (unless you ordered
the second power supply as an option). Plug the power cord into the open
receptacle (PWR1). If you are using redundant power supplies, you may
use both receptacles to achieve redundancy. See the zx6000/rx2600
Operation & Maintenance Guide for complete details.
Chapter 1