Changing The Transmission Oil - APRILIA RS 250 - 1998 Manual

CHANGING
THE TRANSMISSION OIL
Carefully read p. 29 (TRANSMISSION
OIL) and p. 47 (MAINTENANCE).
Check the transmission oil level every
4000 km (2500 mi), change it after the first
1000 km (625 mi) and successively every
12000 km (7500 mi).
To change the oil, proceed as follows:
Start the engine, see p. 40 (STARTING)
and let it idle for a few minutes, in order
to facilitate the outflow of the oil during
the draining phase.
c
Position the vehicle on firm and
flat ground.
Stop the engine and let it cool down for
at least ten minutes, in order to allow the
oil to flow back to the oil pan and to cool
down.
a
When warmed up, the engine
contains hot oil; therefore, while
carrying out the operations de-
scribed here below be particularly care-
ful, in order to avoid burns.
Keep the vehicle in vertical position, with
the two wheels resting on the ground.
Put a container (1) with at least 700 cm C ca-
pacity in correspondence with the drain plug
(2).
Unscrew and remove the drain plug (2).
Unscrew and remove the filling plug (3).
Drain the oil and let it drip into the container
(1) for a few minutes.
Remove the metal residues from the drain
plug (2) magnet.
Screw and tighten the drain plug (2).
Drain plug (2) driving torque:
27 Nm (2.7 kgm).
Pour about 700 cmC of transmission oil
through the filling opening (1), see p. 86
(LUBRICANT CHART).
Tighten the filling plug (1).
Start the engine, see p. 40 (STARTING)
and let it idle for about one minute, in or-
der to ensure the filling up of the tran-
smission oil circuit.
Check the oil level and top up if necessary,
see p. 50 (CHECKING THE TRANSMIS-
SION OIL LEVEL AND TOPPING UP).
use and maintenance RS 250 51