Front Brake - APRILIA RS 125 - 1998 Manual

&2/.4 "2!+%
CHECKING
c
Position the vehicle on firm and
flat ground.
Position the vehicle on the stand, and ro-
tate the handlebar completely right-
wards.
Make sure that the fluid level exceeds
the "MIN" mark.
If the fluid does not reach the "MIN"
mark, provide for topping up.
TOPPING UP
a
The brake fluid may flow out of
the tank. Do not operate the front
brake lever if the brake fluid tank
plug is loose or has been removed.
Unscrew and remove the plug (1).
a
Avoid any prolonged exposure
of the brake fluid to the air.
The brake fluid is hygroscopic
and when in contact with the air it ab-
sorbs its humidity.
Leave the brake fluid tank open ONLY
for the time necessary for topping up.
Remove the gasket (2).
c
In order not to spill the brake flu-
id w hile topping up, do not
shake the vehicle.
Fill the tank (3) with brake fluid, see p. 81
(LUBRICANT CHART), until reaching
the correct level between the "MIN" and
"MAX" marks.
a
When topping up, never exceed
the "MAX" level.
It is advisable to top up until
reaching the "MAX" level only with new
pads.
When the disc pads wear out, the level
of the fluid decreases progressively to
compensate for their wear.
Do not reach the "MAX" level with worn
out pads, since this will cause a fluid
outflow when the pads are changed.
To reassemble the components, follow
the reverse order.
a a
Check the braking efficiency. If
necessary, contact your APRILIA
Official Dealer.
In case of excessive stroke of the brake
lever, of excessive elasticity or in case
there is air in the circuit, contact your
APRILIA Official Dealer, since it may be
necessary to bleed the system.
use and maintenance RS 125 27