APRILIA RS 125 - 1998 Manual page 71

!$*534).' 4(% 6%24)#!,
(%!$,)'(4 "%!-
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
Working on the rear left side of the front
part of the fairing, adjust the appropriate
screw (1) by means of a short cross-tip
screwdriver.
By SCREWING IT (clockwise), you set
the beam upwards.
By UNSCREWING IT (anticlockwise),
you set the beam downwards.
"5,"3
Carefully read p. 43 (MAINTENANCE).
a
Before changing a bulb, turn the
ignition switch to position "
Change the bulb wearing clean
gloves or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to prevent it from blowing.
DO NOT FORCE THE ELECTRIC
CABLES.
use and maintenance RS 125
m
".
71