APRILIA RS 125 - 1998 Manual page 73

LOW BEAM BULB
Working on the rear left side of the front
part of the fairing, move the protection el-
ement (11) with your hands.
Withdraw the connector (12).
Release the check spring (13) positioned
at the rear of the bulb socket (14).
Extract the bulb (15) from its seat.
c
Insert the bulb in the bulb sock-
et, making the relevant position-
ing seats coincide.
Correctly install a new bulb of the same
type.
#(!.').' 4(% &2/.4 !.$ 2%!2
$)2%#4)/. ).$)#!4/2 "5,"3
Carefully read p. 71 (BULBS).
c
Before changing a bulb, check
the fuses, see p. 68 (CHANGING
THE FUSES).
Position the vehicle on the stand.
Unscrew and remove the screw (16).
c
While removing the protection
screen, proceed carefully in or-
der not to break the cog.
Remove the protection screen (17).
c
Upon reassembly, correctly po-
sition the protection screen in its
seat.
Tighten the screw (16) moderately and
carefully, to avoid damaging the protec-
tion screen.
Press the bulb (18) slightly and rotate it
anticlockwise.
c
Extract the bulb from its seat.
Insert the bulb in the bulb sock-
et, making the two bulb pins co-
incide with the relevant guides on the
socket.
Correctly install a new bulb of the same
c
type.
If the bulb socket (19) goes out
of its seat, insert it correctly,
making the bulb socket opening coin-
cide with the screw seat.
use and maintenance RS 125 73