APRILIA RS 125 - 1998 Manual page 30

!$*534).' 4(% 2%!2 "2!+%
The brake pedal is positioned ergonomical-
ly during the assembly of the vehicle.
If necessary, it is possible to adjust the
height of the brake pedal:
Loosen the lock nut (1).
Unscrew the brake adjuster (2) completely.
Screw the lock nut (3) completely on the
pump control rod (4).
Screw the pump control rod (4) complete-
ly, then unscrew it by giving 3-4 turns.
Screw the brake adjuster (2) until the
brake pedal (5) reaches the desired
height.
Lock the brake adjuster (2) by means of
the lock nut (1).
Unscrew the pump control rod (4) and
bring it in contact with the pump piston.
Screw the rod in order to ensure a mini-
mum clearance of 0.5 1 mm between
the pump control rod (4) and the pump
piston.
30
use and maintenance RS 125
a
Make sure that there is a certain
clearance between the brake ad-
juster and the point of contact,
to prevent the brake from remaining op-
erated and the consequent untimely
wear of the braking elements.
Clearance between brake adjuster and
point of contact: 0.5 1 mm.
Lock the pump control rod by means of
the lock nut (3).
a
Check the braking efficiency.
If necessary, contact an APRILIA
Official Dealer.
After the adjustment, make sure that the
wheel rotates freely with released
brake.
!$*534).' 4(% #,54#(
Adjust the clutch and if the engine stops or
tends to advance when the clutch lever is
pulled and the gears are engaged, or if the
clutch slips causing a delay in the acceler-
ation in comparison with the engine speed.
Minor adjustments can be carried out by
means of the adjuster (6):
Withdraw the protection element (7).
Loosen the nut (8) (by screwing it).
Rotate the adjuster (6), until the idle
stroke at the end of the clutch lever is
about 10÷15 mm (see figure).
Tighten the nut (8) (by unscrewing it) and
lock the adjuster (6).
Check the idle stroke at the end of the
clutch lever.
Put back the protection element (7).