APRILIA RS 125 - 1998 Manual page 56

2%-/6).' 4(% 2)$%2 3!$$,%
Position the vehicle on the stand.
Insert the key (1) in the lock (2).
Rotate the key (1) anticlockwise.
Raise and remove the saddle (3).
Remove the flap (4).
c
Upon reassembly:
Before lowering and locking the
saddle, make sure that you have
not left the key in the glove / tool kit
compartment.
Position the flap (4) correctly.
Insert the rear tangs (6) of the saddle in
the appropriate seats (see figure).
Position the coupling (5) in its seat, lower
and press the saddle, making the lock
snap.
a
Before leaving, make sure that
the saddle (3) is properly posi-
tioned and locked.
56
use and maintenance RS 125
2%-/6).' 4(% 3)$% &!)2).'3
Carefully read p. 43 (MAINTENANCE).
a
Wait until the engine and the ex-
haust silencer have completely
cooled down.
Position the vehicle on the stand.
Unscrew and remove the four screws
(7).
Disconnect the two electric terminals (8)
of the direction indicator.
Unscrew and remove the two lower
screws (9).
For the left fairing: unscrew and re-
move the two rear screws (10).
For the right fairing: unscrew and re-
move the rear screw (11).
Unscrew and remove the four screws
(12).
a
Handle the plastic and painted
components with care and avoid
scraping or damaging them.
Remove the side fairing (13).