Defretter; Delay - Boss BR-1200CD Owner's Manual

Insert effect parameter functions

Defretter

This effect simulates the sound of a fretless bass.
On/Off
This parameter turns the defretter effect on or off.
Sensitivity
This controls the input sensitivity of the defretter. Adjust this
parameter until your guitar's harmonic changes sound natural.
Attack
This parameter controls the attack of the defretter. Increasing the value
will cause the harmonics to change more slowly, thus producing a
relatively attack-less sound, similar to that of a fretless bass.
Depth
This controls the ratio of harmonics. Increasing the value will increase the
harmonic content and therefore will create a more unusual sound.
■ When "COSM OD GUITAR AMP"
algorithm is selected
Tone
Adjusts the amount of blurring between the notes.
Resonance
Adds a characteristically resonant quality to the sound.
Effect Level
Adjusts the volume of the defretter sound.
Direct Level
Adjusts the volume of the direct sound.
■ When algorithm other than "COSM OD
GUITAR AMP" is selected
Level
Adjusts the volume of the defretter sound.
300

Delay

This effect creates a thicker sound by applying a delayed
sound to the direct sound.
OFF, ON
On/Off
This parameter turns the delay effect on or off.
0–100
Type
This parameter selects the type of delay to be used.
* This is not displayed when the algorithm is "VO+GT.AMP" or
0–100
"VO+AC.SIM."
SINGLE:
A simple delay.
Pan:
0–100
The delayed sound is panned across the left and right channels. This
type of delay will be effective when stereo output is used.
Feedback
This parameter adjusts the amount of feedback. Changing the
amount of feedback also causes the number of individual repetitions
-50–+50
of the delayed sound to change.
Effect Level
0–100
Adjusts the overall volume of the delay sound.
■ When "COSM OD GUITAR AMP" or
"COSM OD BASS AMP" algorithm is selected
0–100
Delay Time
This parameter adjusts the delay time (i.e., the interval for which
0–100
sound is delayed).
Tap Time
Adjusts the delay time of the right channel delay. This setting adjusts
the R channel delay time relative to the L channel delay time
0–100
(considered as 100%).
Hi Cut Freq
This sets the frequency at which the high cut filter begins to take
effect. This allows you to get a mild effect sound by cutting the high-
end component above the set frequency.
When it is set to "Flat," the high cut frequency is off or has no effect.
■ When algorithm other than "COSM OD GUITAR
AMP" and "COSM OD BASS AMP" is selected
Delay Time
This parameter adjusts the delay time (i.e., the interval over which
sound is delayed).
SINGLE, PAN
0–1800 ms
0–100% (Type = Pan)
700 Hz–11.0 kHz, Flat
SINGLE: 1–1400 ms, PAN: 1–700 ms
OFF, ON
0–100
0–120