Boss BR-1200CD Owner's Manual page 21

5. INPUT LEVEL knob
Adjusts the volume of all input sources, and the volumes
determined using this knob are the actual volumes that will
be recorded on tracks.
6. TUNER ON/OFF button
Use this button to turn the tuner (p. 275) on and off.
7. REC MODE (recording mode) button
This is used to prepare the BR-1200CD for recording. In
addition, it also allows you to select one of the following
three recording modes:
INPUT:
Allows you to record the instruments and microphones
connected to the input jacks. The units is normally used in
this mode.
BOUNCE:
Allows you to mix the audio from several tracks and to
record it on one or two different tracks.
MASTERING:
Allows you to master your finished songs using the BR-
1200CD's Mastering Tool Kit.
8. REC MODE (recording mode) indicators
Allow you to confirm which recording mode is currently
selected. Whenever you change the recording mode using
the REC MODE button, the INPUT, BOUNCE, or
MASTERING indicator will light up accordingly.
9. MARKER
The MARKER section is used to make settings for the marker
function.
MARK button:
Use this button to position a marker at any point within your
song. Each time this button is pressed, the BR-1200CD will
place a marker at the current position.
Markers are numbered in sequence from the beginning of the
song. In addition, you can also assign names to individual
markers. If a marker has been placed at the current position,
the corresponding number will appear in the display's
Marker box; if no marker has been placed here, the Marker
box will show the number of the last marker before the
current position. Appropriately placed markers allow you to
quickly confirm which section of the song is being played.
"Placing markers in your song (Marker)" (p. 90)
SEARCH button:
Use this button to jump back to the previous marker before
the current position.
SEARCH button:
Use this button to jump forward to the next marker after the
current position.
CLEAR button:
Use this button to delete markers. Specifically, the marker
currently being shown in the display's Marker box will be
deleted when this button is pressed.
10. AUTO PUNCH IN/OUT
The AUTO PUNCH IN/OUT section is used to make settings
for the auto punch in/out function.
ON/OFF button:
This button is used to turn the auto punch function on and
off. The button's indicator will light up when auto punch is
on.
IN button:
Sets the punch-in position. When pressed, the current
position is registered as the punch-in position and the
button's indicator lights up. Once a punch-in position has
been registered, you can jump to this position at any time by
pressing [IN].
OUT button:
Sets the punch-out position. When pressed, the current
position is registered as the punch-out position and the
button's indicator lights up. Once a punch-out position has
been registered, you can jump to this position at any time by
pressing [OUT].
DELETE button:
Deletes the current punch-in or punch-out position. To do
this, hold down [DELETE] and then press either [IN] or
[OUT] to delete the corresponding auto punch position.
When the [IN] or [OUT] setting is cleared in this way, its
indicator will be turned off.
Panel Descriptions
21