Writing Several Songs At Once (Disc At Once By Song) - Boss BR-1200CD Owner's Manual

Creating Audio CD
10. Press [ENTER/YES].
The message "Now Writing..." will appear and writing
to the audio CD will begin. When writing has been
completed, the message "Finalize OK?" will be
displayed.
11. If you intend to write additional songs to the same CD-
R disc, press [EXIT/NO].
Alternatively, press [ENTER/YES] if no more songs
will be added to this disc.
If you press [ENTER/YES], the message "Finalizing..."
will appear and the finalization process will begin. When
the message "Complete!" appears, it indicates that the
finalization has been completed. For more detailed
information regarding finalization, refer to "What is
finalization?" (p. 222).
12. Press [EXIT/NO] several times to return to the top
screen.
13. Press the CD-R/RW drive's EJECT button to eject the
disc.
This completes the writing process.
It may take a period of several seconds before the disc is
actually ejected.
• The range of available write speeds can sometimes
be limited by the type of media being used. In such a
case, the BR-1200CD will allow you to select only the
supported speeds.
• If an error occurs, try changing the write speed and
then carry out the writing process over again.
• The actual time required to complete writing to a
disc will be longer than the time calculated from the
write speed. The data is converted into CD format
during the writing process, and this accounts for the
extra time requirement.
220
Writing several songs at once
(Disc At Once By Song)
1. Insert an unrecorded CD-R or CD-RW disc into the CD-
R/RW drive.
2. Press [AUDIO CD WRITE/PLAY].
The Audio CD screen will appear.
fig.07-57d
3. Press [F1] (WRITE).
The Audio CD Write screen will appear.
fig.40-02d
4. Press [F2] (DISC).
The Disc At Once Menu screen will appear.
fig.07-64d
5. Press [F1] (BY SONG).
The Disc At Once By Song screen will appear.
fig.05-130d
• If the message "Not Blank Disc!" appears, it means that
the CD-R disc already contains data. In such a case,
replace the disc with an unrecorded one.
• If the message "Erase Disc?" appears, it means that the
CD-RW disc already contains data. If you then press
[ENTER/YES], the BR-1200CD will begin erasing data
from the CD-RW disc. Once this process has been
completed, you can proceed to the following steps using
the empty CD-RW disc.