Placing Originals; Placing Originals On The Exposure Glass - Ricoh Aficio SPC222SF User Manual

Placing Originals

This section describes the procedure for placing originals on the exposure glass
and in the ADF.
Important
❒ Do not place originals before any correction fluid and toner has completely
dried. Doing so may make marks on the exposure glass that will appear on
copies.
❒ The original in the ADF takes precedence over the original on the exposure
glass if you place originals both in the ADF and on the exposure glass.
Note
❒ Because colors made by marker or highlighter pen on originals are difficult to
reproduce, they might not appear on copies, or might appear as different colors.

Placing originals on the exposure glass

The exposure glass enables you to scan and send documents that cannot be fed
into the ADF.
Important
❒ Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or
be damaged.
A
Lift the exposure glass cover or ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might
be damaged.
B
Place the original face down on the exposure glass. The original should be
aligned to the rear left corner.
C
Lower the exposure glass cover or ADF.
BAA050S
Placing Originals
2
87