Common Problems - Ricoh Aficio SPC222SF User Manual

Troubleshooting

Common Problems

This section describes how to troubleshoot common problems that may occur
while operating the machine.
Problem
The machine does not
turn on.
An error message is
shown on the ma-
chine's screen.
Pages are not printed.
Pages are not printed.
Strange noise comes
from the area where a
supply or an option is
recently installed.
The volume of the
sounds produced by
the machine is too loud.
The volume of the
sounds produced by
9
the machine is too qui-
et.
Note
❒ If any of these problems persist, turn off the power, pull out the power cord,
and contact your sales or service representative.
220
Possible cause
The power cord is not
connected properly.
An error has occurred.
The machine is warm-
ing up or receiving da-
ta.
The interface cable is
not connected correct-
ly.
The supply or option is
not properly installed.
The volume is set to the
high level.
The volume is set to Off
or the low level.
Solution
• Make sure that the power plug is firmly
inserted into the wall outlet.
• Make sure that the wall outlet is not de-
fective by connecting another working
device.
See p.239 "Error and Status Messages on the
Screen".
Wait until "Printing" appears on the screen.
If "Processing" is displayed on the screen,
the machine is receiving data.
• Reconnect the cable.
• Check that the interface cable is the cor-
rect type.
Confirm that the supply or option is proper-
ly installed.
Adjust the volume of the beep, ring, speak-
er, and alarm sounds . For details, see p.180
"Machine Settings".
Adjust the volume of the beep, ring, speak-
er, and alarm sounds . For details, see p.180
"Machine Settings".