Procedure 26; Manual Configuration - Nortel 2001 Installation And Operation Manual

Dynamic IP address assignment — Partial DHCP
For a partial DHCP installation, you must provide, through the IP Phone 2007
dialpad, the Connect Server parameters including: IP address, port number,
action, and retry count. Other parameters (IP Phone IP address, subnet mask,
and default Gateway) are retrieved from the DHCP server.
The IP Phone 2007 password, node ID and TN must be entered manually
from the dialpad.
For more information about DHCP servers, see Converging the Data
Network with VoIP (553-3001-160).
Go to Procedure 27, "Installing an IP Phone 2007 for the first time using
DHCP" on page 158.
Dynamic IP address assignment — Full DHCP
For a full DHCP installation, all parameters (IP Phone IP address, subnet
mask, default Gateway, Connect Server IP address, port number, action, and
retry count) are retrieved from the DHCP server to recognize the
IP Phone 2007.
The IP Phone 2007 password, node ID and TN must be entered manually
from the dialpad.
For more information on how to set up DHCP servers for use with the
IP Phone 2007, refer to Converging the Data Network with VoIP
(553-3001-160).
Go to Procedure 27, "Installing an IP Phone 2007 for the first time using
DHCP" on page 158.

Procedure 26

Installing an IP Phone 2007 for the first time using

manual configuration

1 Configure a virtual loop on the system using LD 97.
For more information, see Software Input/Output: Administration
(553-3001-311).
2 Configure the IP Phone 2007 on the system using LD 11.
Nortel IP Phone 2007
IP Phones Description, Installation, and Operation
Page 151 of 430