First-Time Installation - Nortel 2001 Installation And Operation Manual

First-time installation

IP address assignments
2 To install and configure an IP Phone 2002, the host system must be
installed with the Voice Gateway Media Card.
3 If an AC power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 8 on
4 Understand the three configuration modes that you can choose as you
proceed through the installation of the IP Phone 2002. The three
configuration modes are:
• Static IP address
• Dynamic Partial DHCP (see "Dynamic IP address assignment —
Partial DHCP" on
• Dynamic Full DHCP (see "Dynamic IP address assignment — Full
DHCP" on
5 A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
During the first-time installation, there are IP address parameters that are
entered either manually or automatically depending on the installation
configuration. As well, you are prompted to enable or disable 802.1Q. For
more information, see "802.1Q VLAN description" on
There are three configuration modes you can choose from to obtain the IP
parameters. Review the following sections for more information on the
configuration mode that you are using.
Static IP address assignment
During the installation, the IP Phone 2002 parameters are entered manually
using the key pad.
Nortel IP Phone 2002
(
see "Static IP address assignment" on
page 74)
page 74)
End of Procedure
IP Phones Description, Installation, and Operation
Page 73 of 430
page 71.
page 353.
page 73)