FVS318 or FVM318 with FQDN to FVL328
This appendix is a case study on how to configure a VPN tunnel from a NETGEAR FVS318 or
FVM318 to a FVL328 using a Fully Qualified Domain Name (FQDN) to resolve the public
address of one or both routers. This case study follows the VPN Consortium interoperability
profile guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html). The
configuration options and screens for the FVS318 and FVM318 are the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table G-1.
Profile Summary
VPN Consortium Scenario:
Type of VPN
Security Scheme:
Date Tested:
Model/Firmware Tested:
NETGEAR-Gateway A
NETGEAR-Gateway B
IP Addressing:
NETGEAR-Gateway A
NETGEAR-Gateway B
NETGEAR VPN Configuration FVS318 or FVM318 with FQDN to FVL328
NETGEAR VPN Configuration
Scenario 1
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
IKE with Preshared Secret/Key (not Certificate-based)
April 2003
FVS318 firmware version A1.4 or FVM318 firmware version 1.1
FVL328 with firmware version 1.4 Release 1A
Fully Qualified Domain Name (FQDN)
Static IP address
M-10146-01
Appendix G
G-1